Leister UNIROOF AT profiles are preset parameters for drive speed, air temperature and air volume. When selected, the Leister UNIROOF AT will configure itself with those settings and begin the heat up process.
The UNIROOF AT comes with six preset profiles (below), and allows users to save up to 10 additional profiles.
Welding Profile | Welding Speed (ft./ min.) | Air Temp (°F) | Air Volume (%) | |
1 | BASIC | Adjustable | Adjustable | Adjustable |
2 | PVC | 8.2 | 1022 | 100 |
3 | TPO | 9.8 | 842 | 100 |
4 | EVA | 6.6 | 1004 | 100 |
5 | PIB | 6.6 | 850 | 100 |
6 | EPDM Modif. | 5.2 | 1148 | 85 |
7-16 | Own | Adjustable | Adjustable | Adjustable |
BASIC is the flexible Start welding profile of your UNIROOF. It allows you to use the values that were most recently set when you switch the device on (Profile 1).
Profiles 2-6 are predefined for welding specific materials under ideal conditions. The settings should be tweaked for each project until a strong weld is created on test material.
If you should change the set points of any saved welding profile (Profiles 2-16), the saved welding profile will remain available and unchanged for later use.
Following are directions for creating your own profiles. Using the control panel:
Your newly created profile is now saved and can be accessed at any time under the preset profiles.
Once a profile is created it is not set in stone. You can easily adjust a profile’s settings using the following steps:
Your revised profile is now saved and can be accessed at any time under the name that has been entered.
© 2024 Hy-Tech Products, Inc. All rights reserved. Terms of Use